Denky D4 - unable to reset
-
Hi Charles,
This Denky D4 was working, but after a long pause, it seems to have died. I've tried pressing Reset, and then running Web Flasher. I then get this message:"Failed to enter bootloader mode: Couldn't sync to ESP. Try resetting manually. Last error: Sync timeout or abandoned"
Any help appreciated.
Thanks -
Hi Charles,
This Denky D4 was working, but after a long pause, it seems to have died. I've tried pressing Reset, and then running Web Flasher. I then get this message:"Failed to enter bootloader mode: Couldn't sync to ESP. Try resetting manually. Last error: Sync timeout or abandoned"
Any help appreciated.
ThanksHi,
This 'Sync timeout' error means the ESP chip is refusing to enter 'bootloader mode' (the mode needed to flash the firmware).
Here are the best ways to fix it:
- Force Bootloader mode manually
If your Denky D4 has a BOOT button: Press and hold it.
While holding the BOOT button, press the Reset button once (or plug the USB cable in).
Release the BOOT button after 1 or 2 seconds.
Try the Web Flasher again.
(Note: If you don't have a BOOT button, you have to use a small wire to connect the GPIO0 pin to GND while plugging the USB in).
-
Use a better flashing tool
Web browsers sometimes struggle with the ESP timing. Instead of the Web Flasher, download a standalone software called ESP-Flasher. It is usually much more reliable. -
Check your hardware
Make sure you are using a high-quality USB data cable (some cables only provide power).
Plug the USB cable directly into your computer's motherboard, avoiding USB hubs or extension cords.
-
Hi,
This 'Sync timeout' error means the ESP chip is refusing to enter 'bootloader mode' (the mode needed to flash the firmware).
Here are the best ways to fix it:
- Force Bootloader mode manually
If your Denky D4 has a BOOT button: Press and hold it.
While holding the BOOT button, press the Reset button once (or plug the USB cable in).
Release the BOOT button after 1 or 2 seconds.
Try the Web Flasher again.
(Note: If you don't have a BOOT button, you have to use a small wire to connect the GPIO0 pin to GND while plugging the USB in).
-
Use a better flashing tool
Web browsers sometimes struggle with the ESP timing. Instead of the Web Flasher, download a standalone software called ESP-Flasher. It is usually much more reliable. -
Check your hardware
Make sure you are using a high-quality USB data cable (some cables only provide power).
Plug the USB cable directly into your computer's motherboard, avoiding USB hubs or extension cords.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login