ESP8266-01 auto reset with FT231XS not working
-
I created a new design using the FT231XS chip that has RTS and DTR pins to allow me to program an ESP8266-01 module without holding down a button and powering it up. The two NPN transistors used in other designs should take care of things.
Right now in the Arduino IDE things look fine.
-power is going where it should
-the FTDI com port appears
-programming leds blink for a second but the sketch will not uploadCan someone take a look at the attached schematic to see if anything obvious was left out? I'll poke around with the oscilloscope over the next few days to find the problem.
Mike - See more at: http://www.esp8266.com/viewtopic.php?f=13&t=10223#sthash.6nc9Gyd7.dpuf[0_1464802364297_Schematic.1PDF.PDF](Uploading 100%)
-
Hi @miker
Nice to see old OLED board creator there
Your schematic looks good, at which speed did you tried to upload ? Did you programmed the FTDI chip with FT_PROG to see pin setup and functions ?
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login